1. Screw your trunk pipe until it touches the
plastic ring in the trunk.
2. Fill the glass base of the water pipe with cold water. 8-10 pieces
of ice can be added into the water.
3. Screw your trunk to glass base until the base contracts the ring,
in the trunk.
4. Make sure that the tube from the trunk pipe should be immersed into
the water about 1-2 cm if the water level is not proper, arrange the
level of water accordingly.
5. Attach the hose to the trunk and make sure that the joint is airtight.
6. Test that your setup is airtight by placing your hand on top of the
water pipe and then sucking in through the hose. There should not come
any air through. If any bubbles are formed in the water, it means that
air comes through, in this case check the rings of both trunk pipe and
glass base which is located inside the trunk and if it is necessary
you should screw them a bit more without forcing.
7. Put some of the tobacco into the Ceramic Tobacco Bowl crumbling into
the small pieces. The level of tobacco should not exceed over the border
of the Ceramic Tobacco Bowl.
8. Cover the tobacco bowl with the aluminum foil which is to be as big
as to wrap the border. Then, stroke the aluminum foil around to supply
airtight. (It is recommended to use thick foil.)
9. The foil should be pierced as shown in the picture with your tong'
s. string or something sharp.
10. Place the tobacco bowl on the top of the trunk with the bowl seal
to joint airtight.
11. Now light your charcoal of your water pipe. After your charcoal
is burned, turn off your oven and let it wait 3 - 5 minutes until the
surface of it gets white and locate them on the tobacco bowl as shown
in the picture with your tong. At start just put three pieces. After
they get smaller and die down, you put two pieces to go on.
12. After 4- 5 minutes locating the charcoal on the bowl, you can start
smoking. It may take 10- 15 minutes to reach the top level of satisfaction
(yield)